> The setting was to go into Network Settings, select the USB Loopback which has been renamed ” Ethernet 2 ” and rename it to “USB” then go into its settings just like you would ENET lead and set the IPV4 IP to 169.254.0.8 with a mask of 255.255.0.

The Windows Networking and Networking Toolkit for Networking and Networking. However I did it nicely and ISTA-P runs nicely too, and with the excellent Loader V4.3. Loader V3.2 and ISTA-P was a bit more tricky. Put all correct files in sharedstorage and install all.Īfter the Windows 10 update (which failed the first two attempts because it turned out the BIOS needed an update first) most applications were fine.īy simply revisiting the COM port settings for my K + DCAN USB to set back to COM9, minimum buffer sizes and minimum latency Rheingold ran perfectly. Install Vredist 20, net framework 4.6.1 or 4.6.2 Start using engineering software (INPA, WinKFP, etc.) The IP address must be set to correct 169.254.92.38, click “CHECK” buttonĬonfiguration is done. Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.2010 BMW 750Li (F02) V84.4L Turbo (N63) For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming. ICOM Device status will be changed to Reserved.Ģ) Open Eas圜onnect, do following settings. Select vehicle type, BMW, MINI, BMW Motorcycle or Rolls RoyceĬlick “Extras” tab> “Settings” to change language and other settingsĬlick “Settings” to change language and othersĮngineering & programming software INPA, NCS-Expert, WInKFP etcīefore using the engineer tools, must set/configure ICOM settingsġ) Open Engineer Tools, Itool Radar, select first line option, click “Reserve” button on the right (If the Status shows firmware, you see update ICOM firmware first, see instruction in Part 5)Ĭheck the resolution on desktop, it is the same as ISTA-P resolution you just chose. When it shows ICOM, you can click lower right corner Connect to start diagnosis. Go to Operations, then Read Out Vehicle Data, press Complete identificationįollow ISTA prompt to connect the ICOM emulator with vehicle Double click RHEINGOLD icon to change Full Screen

Bmw ista size